Welcome, Guest. Please login or register.
Did you miss your activation email?
December 22, 2024, 09:37:55 am
« previous next »
Pages: [1]

Author Topic: REPLAcE OF 99 7 GAUGE INSTRUMENTS : NO mdc availabe.  (Read 2346 times)

Capt Rick

  • Toyota should pay me
  • *****
  • Posts: 1252
  • Karma: +6/-0
  • I'm a llama!
    • View Profile
    • Email
REPLAcE OF 99 7 GAUGE INSTRUMENTS : NO mdc availabe.
« on: September 16, 2021, 14:48:06 pm »
MGA0010911   MDC replacement, 1999 Instrument 7 Gauge Dash, replace w Analog Rick Cohn 10200 Newington drive Orlando, Fl 32836   10    2    $749.00    35.
This includes alarms for low oil pressure and 2 heat sensors for hot exhaust risers.

EMAIL Boatetrade@aol.com

Capt Rick 4077014430

2 kits in stock
Logged

Capt Rick

  • Toyota should pay me
  • *****
  • Posts: 1252
  • Karma: +6/-0
  • I'm a llama!
    • View Profile
    • Email
Re: REPLAcE OF 99 7 GAUGE INSTRUMENTS : NO mdc availabe.
« Reply #1 on: November 26, 2021, 13:53:09 pm »
1 Kit in stock. Send old MDC and wiring to gauges.

Capt Rick
4077014430
Logged

Capt Rick

  • Toyota should pay me
  • *****
  • Posts: 1252
  • Karma: +6/-0
  • I'm a llama!
    • View Profile
    • Email
Re: REPLAcE OF 99 7 GAUGE INSTRUMENTS : NO mdc availabe.
« Reply #2 on: July 20, 2022, 11:24:27 am »
sorry price inflation plus very hard to get gauges

MGA0010911   MDC replacement, 1999 Instrument 7 Gauge Dash, replace w Analog Rick Cohn 10200 Newington drive Orlando, Fl 32836   10    2    $933    $45

Capt Rick
boatetrade@aol.com
4077014430 east coast time 9-9
Logged

Capt Rick

  • Toyota should pay me
  • *****
  • Posts: 1252
  • Karma: +6/-0
  • I'm a llama!
    • View Profile
    • Email
Re: REPLAcE OF 99 7 GAUGE INSTRUMENTS : NO mdc availabe.
« Reply #3 on: July 31, 2023, 20:21:28 pm »

Send all gauges and MDC and all wires. see attached picture.
Logged

Capt Rick

  • Toyota should pay me
  • *****
  • Posts: 1252
  • Karma: +6/-0
  • I'm a llama!
    • View Profile
    • Email
Re: Replace OF 99 7 GAUGE INSTRUMENTS : NO MDC needed.
« Reply #4 on: July 31, 2023, 20:24:33 pm »
Steps to removing MDC, gauges and wiring.

Battery switch off.
Remove 2 screw cap next to windshield, using short stub Phillips screwdriver remove 2 screws.
 
 
Remove 2 screws caps on bottom front and nuts w 3/8 wrench.
Remove stereo cover and back securing strap  slide stereo forward.

Tilt dash up a get a small box to hold up dash.
Remove the nuts with deep socket 5/16
Remove wire clip holding wires to each gauges. Push gauges out from back with twisting motion.
Remove 4 screws holding the Medallion MDC from under dash ( removing the fire extinguisher) and the kick board there are 4 Phillips screws holding it. Remove the speedometer Hoses cut at fitting.
Remove alarm wire at top. Remove the 6 pin plug and the 12 pin plug attached to MDC end of wiring harness.
 
ship to Rick Cohn 10200 Newington Drive Orlando Fl 32836
allow 1 week to process. questions 407-701-4430
Logged
Pages: [1]
« previous next »