Steps to removing MDC, gauges and wiring.
Battery switch off. Remove 2 screw cap next to windshield, using short stub Phillips screwdriver remove 2 screws.
Remove 2 screws caps on bottom front and nuts w 3/8 wrench. Remove stereo cover and back securing strap slide stereo forward.
Tilt dash up a get a small box to hold up dash. Remove the nuts with deep socket 5/16 Remove wire clip holding wires to each gauges. Push gauges out from back with twisting motion. Remove 4 screws holding the Medallion MDC from under dash ( removing the fire extinguisher) and the kick board there are 4 Phillips screws holding it. Remove the speedometer Hoses cut at fitting. Remove alarm wire at top. Remove the 6 pin plug and the 12 pin plug attached to MDC end of wiring harness.
ship to Rick Cohn 10200 Newington Drive Orlando Fl 32836 allow 1 week to process. questions 407-701-4430
