Author Topic: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's. (Read 2548 times)

Capt Rick · « **on:** July 11, 2023, 17:18:14 pm »

MDC replacement MDC replacement, 1999 Instrument 7 Gauge Dash, replace w Analog Rick Cohn 10200 Newington drive Orlando, Fl 32836 $933.00 $45.

Email Capt Rick at Boatetrade@aol.com or text 4077014430
for instructions and what to send!

IN stock was not available for a year!

Capt Rick · « **Reply #1 on:** July 14, 2023, 00:35:25 am »

I have been able to get a set of factory new gauges. In my stock. You can place order online but need to send old gauges and MDC So I can make it work.

Email me Boatetrade@aol.com

Capt Rick · « **Reply #2 on:** July 18, 2023, 20:41:14 pm »

I have some original gauges but must have a good MDC

Capt Rick · « **Reply #3 on:** August 01, 2023, 01:46:54 am »

parts to send
Steps to removing MDC, gauges and wiring.

Battery switch off.
Remove 2 screw cap next to windshield, using short stub Phillips screwdriver remove 2 screws.

Remove 2 screws caps on bottom front and nuts w 3/8 wrench.
Remove stereo cover and back securing strap slide stereo forward.

Tilt dash up a get a small box to hold up dash.
Remove the nuts with deep socket 5/16
Remove wire clip holding wires to each gauges. Push gauges out from back with twisting motion.
Remove 4 screws holding the Medallion MDC from under dash ( removing the fire extinguisher) and the kick board there are 4 Phillips screws holding it. Remove the speedometer Hoses cut at fitting.
Remove alarm wire at top. Remove the 6 pin plug and the 12 pin plug attached to MDC end of wiring harness.

ship to Rick Cohn 10200 Newington Drive Orlando Fl 32836
allow 1 week to process. questions 407-701-4430

Capt Rick · « **Reply #4 on:** August 04, 2023, 15:11:58 pm »

There is limited gauges available.

Capt Rick · « **Reply #5 on:** September 07, 2023, 12:05:46 pm »

in stock but manufacture said will be discontinued.

Capt Rick · « **Reply #6 on:** October 13, 2023, 14:53:19 pm »

7 Gauges to replace the MDC that is no longer made. Email me for directions I have a kit ready to ship
Boatetrade@aol.com

Capt Rick · « **Reply #7 on:** March 25, 2024, 14:11:29 pm »

I have 2 complete kits to sell. Call me 4077014430 or email me at boatetrade@aol.com

cloudshady · « **Reply #8 on:** April 25, 2024, 00:37:00 am »

Do you have pictures of what is included in this package

Capt Rick · « **Reply #9 on:** April 25, 2024, 02:28:39 am »

Replace the currnet 7 gauges and use the original wire harness going to MDC. Then install a Heat sensor on Exhaust manifolds and alarm buzzer to protect engine if it fails to pump water.
Email me boatetrade@aol.com for pictures and directions
Capt Rick

Capt Rick · « **Reply #10 on:** April 25, 2024, 18:30:38 pm »

See attached

Capt Rick · « **Reply #11 on:** May 15, 2024, 11:33:47 am »

I have 2 Kits left. Next price kit goes over $1200.

MDC replacement MDC replacement, 1999 Instrument 7 Gauge Dash, replace w Analog Rick Cohn 10200 Newington drive Orlando, Fl 32836 933.00 45. ship

Email Me at boatetrade@aol.com

Capt Rick · « **Reply #12 on:** May 25, 2024, 00:27:39 am »

Yes this is the best solution to replace gauges

See Above for info

When ready email me
Capt Rick
boatetrade@aol.com

Capt Rick · « **Reply #13 on:** June 17, 2024, 01:31:28 am »

There are still conversion kits available
1. You do not need the MDC that is No longer avaiable

Email me at Boatetrade@aol.com I Iwll send you instructions and

Capt Rick

Author Topic: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's. (Read 2548 times)

Capt Rick

Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

cloudshady

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.

Capt Rick

Re: Replace 7 Gauge set with Analog and alarm for oil and hot exhaust manifold's.